Introduction

In this article, we will discuss how to achieve a flawless finish using Benjamin Moore Command paint with a FUJI HVLP sprayer. Benjamin Moore Command paint is known for its fast dry time and durable finish. By following the steps outlined in this guide, you can ensure a professional-quality result every time. So let’s dive in and discover the secrets to spraying Benjamin Moore Command paint with a FUJI HVLP sprayer.

Key Points

  1. Benjamin Moore Command is a waterborne acrylic urethane paint known for its fast dry time and hard finish.
  2. To begin, mix the desired color of Benjamin Moore Command paint in the cup. In this demonstration, Dove White with a satin finish is used.
  3. Depending on the consistency, you may choose to add a few drops of water to thin out the paint.
  4. Stir the paint well to ensure it is properly mixed before spraying.
  5. Use a FUJI HVLP sprayer with a 1.8 tip for optimal results.
  6. Start by spraying the back of the frame, ensuring an even and smooth application.
  7. After about three and a half hours, the paint will be dry to the touch, and you can sand the frame if desired.
  8. Flip the frame and spray the front, following the same process as before.
  9. If you notice an orange peel surface after the first coat, sand the frame and apply another coat, slightly thinning the paint with water.
  10. To achieve an even application, spray one layer in one direction, then spin the frame and repeat the process.
  11. For corners, apply extra paint to ensure a smooth and flat surface.
  12. If you encounter small pinhole bubbles in the corners, sand the frame with 320-grit sandpaper and repeat the painting process.
  13. Allow the frame to dry completely before applying additional coats or handling.
  14. Benjamin Moore Command paint dries quickly, allowing for faster project completion.
  15. After two hours, the paint will be completely dry, and after 22 hours, it will be fully cured.
  16. The quick drying and curing time make this paint ideal for projects with tight deadlines.
  17. The finish of Benjamin Moore Command paint is smooth and free from orange peel effect.
  18. Thin the paint with water by about five percent for optimal spraying results.
  19. Practice spraying on sample pieces or cardboard before applying the paint to your project.
  20. Clean the spray gun thoroughly after each use to prevent clogging and contamination.
  21. Use separate guns for paint and clear finishes to avoid cross-contamination.
  22. Clean the gun by pouring out any remaining paint, wiping the cup and tube, and flushing water and lacquer thinner through the gun.
  23. By following this process, you can achieve a flawless finish with Benjamin Moore Command paint every time.

Conclusion

Spraying Benjamin Moore Command paint with a FUJI HVLP sprayer is a reliable method for achieving a professional-quality finish. The combination of fast dry time, hard finish, and easy application makes this paint a popular choice among woodworkers and DIY enthusiasts. By following the steps outlined in this guide and practicing on sample pieces, you can confidently use Benjamin Moore Command paint for your future projects. With a little practice and attention to detail, you’ll achieve remarkable results every time. So go ahead and unleash your creativity with Benjamin Moore Command paint!